電焊機日常維護方法
2017-11-06
電焊機日常維護方法
Electric welding machine daily maintenance methods
1、檢查焊機機殼接地牢靠。
1, check the welding machine chassis ground.
2、檢查焊機電源、母材接地良好、規范。
2, check the welding power source, good parent metal grounding and specification.
3、檢查電纜連接處要可靠絕緣，用膠帶包扎好。
3, check the cable connection to reliable insulation, tape wound.
4、電源線、焊接電纜與電焊機的接線處屏護罩是否完好。
4, the power cord, welding cable connection with welding machine screen protector are in good condition.
5、焊機冷卻風扇轉動是否靈活、正常。
5, cooling fan operation is flexible, normal welding machine.
6、檢查焊機輸出接線規范、牢固，并且出線方向向下接近垂直，與水平夾角必須大于70°。
6, check the output wiring specification, strong, and the outlet direction down almost vertical, and horizontal Angle must be greater than 70 °.
7、檢查電纜連接處的螺釘緊固，螺絲規格為六角螺栓M10×30，平墊、彈墊齊全，無生銹氧化等不良現象。
7, check the cable connection screw fastening, hex bolt screw specifications for M10 x 30, flat mat, play mat is complete, no rust oxide etc. Bad phenomenon.
8、檢查接線處電纜裸露長度小于10mm。
8, check the connection cable exposed length is less than 10 mm.
Chinese
English
