分享點焊機的日常使用注意事項
2017-11-06
1、使用時如發現交流接觸器吸合不實，說明電網電壓過低，用戶應該首先解決電源問題，電源正常后方可使用。
1, if discover when using ac contactor and false, that power grid voltage is too low, the user should first solve the problem of power supply, power supply is normal rear can use.
需要指出的是，新購買的焊機半個月內如出現主件質量問題，可以更換新的焊機或者更換主件。焊機主機部分保修一年，長期提供維修服務。
It should be pointed out that, newly purchased welder if main parts quality problem within half a month, can replace the new welding machine or change the main parts. Welding machine main machine warranty for one year, long-term to provide maintenance services.
2、一般情況下用戶通知廠方后，根據路程遠近三到七天內服務到位。由于用戶原因而造成的焊機損壞不在保修范圍內。易損件、消耗件不在保修范圍內。
2, usually after the user to inform the manufacturer, according to the service in place far three to seven days. Due to the user caused by the welding machine damage is beyond the scope of the warranty. Wearing parts and consumable parts is beyond the scope of the warranty.
3、點焊機使用前應當先通水后施焊，無水嚴禁工作。冷卻水應保證在0.15--0.2MPa進水壓力下供應5--30℃的工業用水。
3, spot welding machine before use should be water before welding, it is forbidden to work without water. Cooling water should guarantee at 0.15-0.2 MPa water pressure 5-30 ℃ of industrial water supply.
4、冬季點焊機工作完畢后應用壓縮空氣將管路中的水吹凈以免凍裂水管。
4, winter spot welding work after the application of compressed air to the water in the pipe blowing off to avoid frost crack pipes.
開始使用24小時后應將各部件螺絲緊固一次，尤其要注意銅軟聯和電極之間聯接螺絲一定要緊固好，用完后應經常清除電極桿和電極臂之間的氧化物，以保證良好接觸。
Began to use after 24 hours, all parts shall be screw fastening once, especially pay attention to the connection between soft and copper electrode screws must be tightened well, after use should be often remove oxide electrode bar and electrode arm, to ensure good contact.
Chinese
English
